FixVault
Home › Ford › 2007 › Crown Victoria Base, 4.6 V › Repair and Diagnosis › Engine Mechanical › Mechanical › Engine System › In-Vehicle Servicing › Valve Seals › Installation

Valve Seals: Installation

    NOTE: The valve stem seal must be bottomed on the valve seat.
    NOTE: Make sure that the garter spring is present in the valve stem seal.
  1. Use the special tools to install the valve stem seals.
    2. Fig 1: Installing Valve Stem Seals
    GF0013582Courtesy of FORD MOTOR CO.
  2. Install the valve springs. For additional information, refer to Valve Springs .
    3. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article.
  3. If equipped with fire suppression system, repower the system.
About FixVault