FixVault
Home › Ford › 2007 › Crown Victoria Base, 4.6 W › Repair and Diagnosis › Engine Mechanical › Mechanical › Engine System › In-Vehicle Servicing › Intake Manifold › Installation

Intake Manifold: Installation

    NOTE: Align the gasket locator tabs with the slots in the cylinder head.
  1. Install new intake manifold gaskets.
    2. Fig 1: Intake Manifold Gaskets
    GF0013546Courtesy of FORD MOTOR CO.
  2. Install the intake manifold and hand-tighten the 8 bolts.
  3. Install the 8 ignition coil-on-plugs. For additional information, refer to ENGINE IGNITION article.
  4. Position the intake manifold crash bracket and loosely install the bolt and stud bolt.
  5. Tighten the bolts in the sequence shown.
    • Tighten to 25 Nm (18 lb-ft).
    6. Fig 2: Intake Manifold Bolt Tightening Torque Sequence
    GF0013547Courtesy of FORD MOTOR CO.
  6. Tighten the intake manifold crash bracket bolt.
    • Tighten to 25 Nm (18 lb-ft).
  7. Install the EGR system module tube. For additional information, refer to ENGINE EMISSION CONTROL article.
  8. Install the intake manifold shield and the 2 bolts.
    • Tighten to 12 Nm (9 lb-ft).
  9. Connect the throttle control and the TP sensor electrical connectors.
  10. Install the coolant thermostat. For additional information, refer to ENGINE COOLING article.
  11. Install the generator bracket and the 4 bracket bolts.
    • Tighten to 10 Nm (89 lb-in).
  12. Connect the generator electrical connector.
  13. Connect the EVAP canister purge valve hoses to the TB and the EVAP canister purge valve. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  14. Connect the intake manifold vacuum hose to the TB spacer.
  15. Connect the EGR system module vacuum and electrical connectors.
  16. Connect the PCV tube quick connect coupling to the TB spacer. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  17. Connect the brake booster vacuum hose to the intake manifold.
  18. Install the heater hose and spring clamp.
  19. Connect the fuel rail pressure and temperature sensor vacuum and electrical connectors.
  20. Connect the 8 fuel injector electrical connectors.
  21. Install the wire harness retainer to the rear of the intake manifold.
  22. Attach the wire harness retainer to the LH front fuel rail stud.
  23. If equipped, attach the wire harness retainer to the intake manifold crash bracket.
  24. Connect the ground connector to the RH rear fuel rail stud bolt.
  25. Install the wiper mounting arm and pivot shaft. For additional information, refer to WIPERS AND WASHERS article.
  26. Connect the fuel spring lock coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  27. Install the air cleaner and outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
  28. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  29. Fill and bleed the engine cooling system. For additional information, refer to ENGINE COOLING article.
    30. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article.
  30. If equipped with fire suppression system, repower the system.
About FixVault