FixVault
Home › Ford › 2007 › Edge SEL Plus, AWD › Repair and Diagnosis › Engine Mechanical › Mechanical › Engine › In-Vehicle Servicing › Crankshaft Pulley › Installation

Crankshaft Pulley: Installation

  1. Lubricate the crankshaft front seal inner lip with clean engine oil.
    2. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
  2. Using the special tools, install the crankshaft pulley.
    3. Fig 1: Installing Crankshaft Pulley Using Special Tools (303-102) & (303-335)
    GF0017018Courtesy of FORD MOTOR CO.
  3. Using the special tool, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
    • Stage 1: Tighten to 120 Nm (89 lb-ft).
    • Stage 2: Loosen one full turn.
    • Stage 3: Tighten to 50 Nm (37 lb-ft).
    • Stage 4: Tighten an additional 90 degrees.
    4. Fig 2: Installing Crankshaft Pulley Washer & Bolt Using Special Tools (303-D055)
    GF0029104Courtesy of FORD MOTOR CO.
  4. Install the accessory drive belt and the power steering belt. For additional information, refer to ACCESSORY DRIVE .
About FixVault