- Shift interlock system does not release/lock correctly
|
- Circuitry
- Fuse(s):
- Brake pedal position (BPP) switch
- Brake shift interlock actuator
- Brake shift interlock actuator module
|
|
- Selector lever is out of correct gear relationship
|
- Selector lever cable and bracket
- Retainer bracket
- Selector lever linkage
|
|
- Transmission range indicator does not correspond to the gear
|
- Selector lever cable bracket
|
- TIGHTEN the bolts holding the selector lever cable bracket.
|
| |
- Selector lever cable loose from the transmission retainer bracket
|
- TIGHTEN the selector lever cable.
|
| |
|
|
- Transmission control (TC) switch is not operating correctly
|
- Fuse F20 (10A)
- TC switch
- TC switch not cycled during self-test
- Powertrain control module (PCM)
- Circuitry
|
|
- Transmission control indicator lamp (TCIL) is not operating correctly
|
|
|
- Rattle, buzz or other noise
|
|
|
| |
|
- TIGHTEN housing bolts to specification.
|
- Water enters inside the vehicle
|
|
- SECURE grommet to floor panel.
|
| |
- Transmission cover plate loose
|
- SECURE transmission cover plate to floor or INSTALL a new transmission cover plate.
|
| |
- Torn cable assembly grommet
|
|
|
|
|
|
| |
|
- ROUTE the cable to prevent binding.
|
| |
|
- TIGHTEN cable bracket bolts to specification. ADJUST cable.
|
- Selector lever will not shift
|
|
|
| |
- Transmission manual lever jammed
|
- INSTALL a new manual lever.
|
| |
|
|
| |
|
|