FixVault
Home › Ford › 2007 › Focus ST › Repair and Diagnosis › Engine Mechanical › Mechanical › Engine › In-Vehicle Servicing › Valve Springs › Installation

Valve Springs: Installation

    NOTE: Check the seating of the valve collet.
  1. Using the special tools, install the valve spring.
    • Insert the valve spring and the valve spring retainer.
    • Compress the valve spring and install the valve collet using some grease and a small screwdriver.
    2. Fig 1: Identifying Special Tools (303-300, 303-350, 303-472)
    G03897813Courtesy of FORD MOTOR CO.
  2. Disconnect the compressed air supply.
    3. Fig 2: Identifying Special Tools (303-300, 303-350, 303-472)
    G03897813Courtesy of FORD MOTOR CO.
  3. Repeat the appropriate removal and installation steps for all of the other cylinders.
  4. Install the spark plugs. For additional information, refer to ENGINE IGNITION - 2.0L AND 2.3L article.
  5. Coat the valve tappets with clean engine oil and insert them.
  6. Install the camshafts. For additional information, refer to Camshafts .
About FixVault