FixVault
Home › Ford › 2007 › Focus ST › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Automatic Transmission External Controls) › Removal And Installation › Transmission Selector Lever › Removal

Transmission Selector Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  2. Remove the selector lever cable from the selector.
    1. Shift the selector lever to PARK.
    2. Unclip the selector lever cable.
    3. Unclip the selector lever cable outer sleeve.
    3. Fig 1: Removing Selector Lever Cable From Selector Lever
    GF0040007Courtesy of FORD MOTOR CO.
  3. Disconnect the selector lever assembly electrical connector.
    4. Fig 2: Locating Selector Lever Assembly Electrical Connector
    GF0040018Courtesy of FORD MOTOR CO.
  4. Remove the selector lever assembly.
    • Remove the 4 nuts.
    5. Fig 3: Locating Nuts Under Selector Lever Assembly
    GF0040019Courtesy of FORD MOTOR CO.
About FixVault