FixVault
Home › Ford › 2007 › Freestar Base, 4.2 2 › Repair and Diagnosis › Body & Frame › Windows › Window And Glass › General Procedures › Window Glass Adjustment - Front Door

Window Glass Adjustment - Front Door

  1. Remove the front door trim panel and watershield. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Partially lower the front door window glass to within 75 mm (2.95 in) of the full up position.
    3. Fig 1: Lowering Front Door Window Glass
    GF0032734Courtesy of FORD MOTOR CO.
  3. Loosen the nut and washer assemblies.
    4. Fig 2: Nut & Washer Assemblies
    GF0032735Courtesy of FORD MOTOR CO.
  4. Open the front door.
  5. Gently pull the front door window glass fully rearward into the door top glass run.
  6. Tighten the nut to 8 Nm (71 lb-in).
    7. Fig 3: Nut
    GF0032736Courtesy of FORD MOTOR CO.
    NOTE: If the hole is a vertical slotted hole, make sure that the nut and washer assembly is positioned at the bottom of the slot before downward pressure is applied to the window regulator equalizer arm bracket.
  7. Apply downward pressure on the window regulator equalizer arm bracket.
  8. Tighten the nut to 8 Nm (71 lb-in).
    9. Fig 4: Nut
    GF0032737Courtesy of FORD MOTOR CO.
  9. Cycle the front door window glass to make sure of correct operation. Readjust the height if necessary.
  10. Install the front door trim panel and watershield. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
About FixVault