FixVault
Home › Ford › 2007 › Fusion S, Standard › Repair and Diagnosis › Engine Mechanical › Mechanical › Engine - 2.3L › In-Vehicle Servicing › Timing Drive Components › Installation

Timing Drive Components: Installation

  1. Install the camshaft sprockets and the bolts. Do not tighten the bolts at this time.
    2. Fig 1: Locating Camshaft Sprockets And Bolts
    GF0028721Courtesy of FORD MOTOR CO.
  2. Install the timing chain guide and the 2 bolts.
    • To install, tighten to 10 Nm (89 lb-in).
    3. Fig 2: Identifying Bolts And LH Timing Chain Guide
    G03897780Courtesy of FORD MOTOR CO.
  3. Install the timing chain.
    4. Fig 3: Locating Timing Chain
    GF0028718Courtesy of FORD MOTOR CO.
  4. Install the timing chain tensioner arm.
    5. Fig 4: Locating RH Timing Chain Guide
    G03897778Courtesy of FORD MOTOR CO.
  5. Install the timing chain tensioner and the 2 bolts. Remove the paper clip to release the piston.
    • Tighten to 10 Nm (89 lb-in).
    6. Fig 5: Locating Timing Chain Tensioner Bolts And Paper Clip
    GF0024080Courtesy of FORD MOTOR CO.
    CAUTION: The special tool 303-465 is for camshaft alignment only. Using this tool to prevent engine rotation can result in engine damage.
  6. Using the flats on the camshafts to prevent camshaft rotation, tighten the bolts.
    • Tighten to 72 Nm (53 lb-ft).
    7. Fig 6: Identifying Camshafts Sprocket Bolts
    GF0028722Courtesy of FORD MOTOR CO.
  7. Install the engine front cover. For additional information, refer to Engine Front Cover .
About FixVault