FixVault
Home › Ford › 2007 › Mustang Base, 2D Convertible, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission › In-Vehicle Servicing › Solenoid Body Assembly › Removal

Solenoid Body Assembly: Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the drain plug and drain the transmission fluid.
    • Discard the drain plug gasket.
    3. Fig 1: Locating Drain Plug
    GF0015455Courtesy of FORD MOTOR CO.
  3. Disconnect the heated oxygen sensor (HO2S) connectors and retaining clip from the RH pan rail and then position the connectors aside.
    4. Fig 2: Locating Heated Oxygen Sensor (HO2S) Connectors
    GF0015456Courtesy of FORD MOTOR CO.
  4. Remove the HO2S connector from the front of the transmission pan rail.
    5. Fig 3: Locating Heated Oxygen Sensor (HO2S) Connector To Front Of Transmission Pan Rail
    GF0015457Courtesy of FORD MOTOR CO.
    NOTE: The transmission fluid pan gasket is reusable, clean and inspect for damage. If not damaged, the gasket should be reused.
  5. Remove the transmission fluid pan screws, gasket and fluid pan.
    6. Fig 4: Locating Transmission Fluid Pan Gasket
    GF0000924Courtesy of FORD MOTOR CO.
    NOTE: Clean the area around the solenoid body connector to prevent contamination.
  6. Disconnect the solenoid body harness electrical connector.
    7. Fig 5: Locating Transmission Solenoid Electrical Connector
    GF0015466Courtesy of FORD MOTOR CO.
  7. Remove the screws and the transmission fluid filter.
    8. Fig 6: Identifying Transmission Fluid Filter Mounting Screws
    G03948630Courtesy of FORD MOTOR CO.
    CAUTION: Do not damage the solenoid body connector pins.
  8. Remove the solenoid body screws and remove the solenoid body by lifting on the body and pushing the connector from the other side of the case.
    9. Fig 7: Locating Solenoid Body Screws
    GF0015491Courtesy of FORD MOTOR CO.
About FixVault