FixVault
Home › Ford › 2008 › Crown Victoria LX, 4.6 W › Repair and Diagnosis › Engine Mechanical › Fuel System › Fuel System And Engine Control System › Removal And Installation › Fuel Pump Driver Module (FPDM) › Removal And Installation

Removal And Installation

  1. Remove the 3 pin-type retainers and the luggage compartment parcel shelf trim panel.
    2. Fig 1: Locating Pin-Type Retainers & Luggage Compartment Parcel Shelf Trim Panel
    GF0046716Courtesy of FORD MOTOR CO.
  2. Disconnect the fuel pump driver module (FPDM) electrical connector.
  3. Remove the 2 bolts and the FPDM.
    • To install, tighten to 4 Nm (35 lb-in).
  4. To install, reverse the removal procedure.
About FixVault