Rear Entertainment Module (RETM): Removal
NOTE:
Programmable module installation (PMI) only needs to be carried out if the rear entertainment module (RETM) is being replaced.
- Upload the RETM configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
- Remove the 4 screws.
- Remove the RETM.
- Pull down on the sides of the RETM to disengage the clips from the bracket.
- Using a suitable tool, push the rear most U-hook forward and release the U-hooks.
- Hang the RETM on the J-hooks and disconnect the electrical connector.
- Remove the RETM from the J-hooks.
NOTE:
Open the display to access the screws.