FixVault
Home › Ford › 2008 › Edge SE, AWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission Cooling › Removal And Installation › Transmission Fluid Cooler › Installation

Transmission Fluid Cooler: Installation

  1. Position the transmission fluid cooler in place.
  2. Install the 2 transmission fluid cooler support brackets and the 2 bolts.
    • Tighten to 10 Nm (89 lb-in).
    3. Fig 1: Locating Transmission Fluid Cooler Support Brackets & Bolts
    GF0031975Courtesy of FORD MOTOR CO.
  3. Connect the transmission fluid cooler tubes to the transmission fluid cooler.
    4. Fig 2: Locating Transmission Fluid Cooler Tubes On Transmission Fluid Cooler
    GF0031976Courtesy of FORD MOTOR CO.
  4. Install the secondary latches on the transmission fluid cooler.
    5. Fig 3: Locating Secondary Latches On Transmission Fluid Cooler
    GF0031973Courtesy of FORD MOTOR CO.
  5. Connect the transmission fluid cooler tube fasteners to the radiator support.
    6. Fig 4: Locating Transmission Fluid Cooler Tube Fasteners On Radiator Support
    GF0031972Courtesy of FORD MOTOR CO.
  6. Install the front bumper cover. For additional information, refer to BUMPERS article.
  7. Check the transmission fluid level and add transmission fluid as necessary.
About FixVault