Removal And Installation
- Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
- Remove the audio control module (ACM). For additional information, refer to Audio Control Module (ACM) .
- Remove the necessary attachments and move the center console 5 cm (2.0 in) towards the rear of the vehicle. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Disconnect the audio DSP module electrical connectors.
- Remove the 2 lower audio DSP module nuts.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the 2 upper audio DSP module nuts.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the audio DSP module.
- Route the audio DSP module down and towards the passenger side of the vehicle.
- To install, reverse the removal procedure.
- Download the configuration information to the audio DSP module. For additional information, refer to PMI in MODULE CONFIGURATION article.
NOTE:
Module configuration is only required if a new audio digital signal processing (DSP) module is being installed.
NOTE:
The audio DSP module is heavy. Be sure to support the amplifier during removal, or damage to the vehicle may occur.