FixVault
Home › Ford › 2008 › Expedition EL RWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle/Transmission External Controls › Removal And Installation › Selector Lever - Column Shift › Removal And Installation

Removal And Installation

  1. Remove the lower steering column shroud.
    1. Remove the screws and the lower steering column shroud.
    2. Fig 1: Lower Steering Column Shroud
    GF0022861Courtesy of FORD MOTOR CO.
  2. Remove the upper steering column shroud.
  3. Disconnect the electrical connector and the harness from the retaining clips.
    4. Fig 2: Electrical Connector & Retaining Clips
    GF0022880Courtesy of FORD MOTOR CO.
  4. Remove the selector lever bolt.
    • To install, tighten to 18 Nm (13 lb-ft).
    5. Fig 3: Selector Lever Bolt
    GF0022881Courtesy of FORD MOTOR CO.
  5. Remove the selector lever.
    6. Fig 4: Selector Lever
    GF0022882Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
About FixVault