Removal And Installation
CAUTION:
Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to these charges.
NOTE:
When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for the calibration procedures. For module configuration, refer to Programmable Module Installation in MODULE CONFIGURATION
article.
- Remove the hydraulic control unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) .
- Remove the 4 screws and the ABS module.
- To install, tighten to 2 Nm (18 lb-in).
- To install, reverse the removal procedure.
CAUTION:
Make sure that the anti-lock brake system (ABS) module is properly seated to the hydraulic control unit (HCU) and that the torque of the ABS module screws is correct, or damage to the components can occur.