In-Vehicle Servicing: Flexplate: Installation

NOTE: Special bolts are used for installation. Do not use standard bolts.

Install the flexplate and tighten the bolts in the sequence shown in 3 stages.
- Stage 1: Tighten to 50 Nm (37 lb-ft).
- Stage 2: Tighten to 80 Nm (59 lb-ft).
- Stage 3: Tighten to 112 Nm (83 lb-ft).

Fig 1: Identifying Flexplate Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

Install the automatic transaxle. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .