Removal & Installation

Remove the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING article.
Disconnect the ABS module electrical connector.
Disconnect the hydraulic control unit (HCU) pump motor electrical connector.

NOTE: Care must be taken when removing the module from the HCU.

Remove the ABS module.
- Remove the screws in the sequence shown in illustration.
- To install, tighten to 3 Nm (27 lb-in).

Fig 1: ABS Module Screws Removal Sequence

Courtesy of FORD MOTOR CO.

NOTE: Make sure that the ABS module-to-HCU gasket surfaces are clean and that the gasket is correctly installed.