Removal and Installation
WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the RH C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the Fuel Pump (FP) module electrical connector.
- Release the wire harness retainer clip.
- Remove the 2 FP
control module nuts.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
NOTE:
Do not overtighten the fasteners or damage to the module will occur.