FixVault

Four Wheel Drive (4WD) System DTCS

4X4 CONTROL MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Possible Causes Source Perform Test
B1317 Battery Voltage High
  • Generator
4X4 Control Module Go to Pinpoint Test B  under PINPOINT TESTS .
B1318 Battery Voltage Low
  • Blown fuse (B+)
  • Intermittent open on power circuit
  • 4X4 control module connector
4X4 Control Module CHECK smart junction box (SJB) fuses 11 (10A) and 35 (10A). If fuses are OK, go to Pinpoint Test B  under PINPOINT TESTS .
P1635 Tire/Axle Out of Acceptable Range
  • Incorrect size tire installed on vehicle
  • Wheel speed sensor failure
  • Flat or under-inflated tire
4X4 Control Module Go to Pinpoint Test G  under PINPOINT TESTS .
P1824 4-Wheel Drive Clutch Relay Circuit Failure
  • Short to ground on active torque control coupling (ATCC) solenoid (part of rear axle) high circuit
  • 4X4 control module failure
4X4 Control Module CHECK SJB fuse 11 (10A). If the fuse is OK, go to Pinpoint Test E  under PINPOINT TESTS .
P1825 4-Wheel Drive Clutch Relay Open Circuit
  • 4X4 control module harness connector
  • Open in ATCC solenoid (part of rear axle) low circuit
  • Open in ATCC solenoid high circuit
  • Short to ground on ATCC solenoid low circuit
  • Short to ground on ATCC solenoid high circuit
  • Open coil inside ATCC solenoid
  • Short to voltage in ATCC solenoid low circuit
  • 4X4 control module failure
4X4 Control Module CHECK SJB fuses 11 (10A) and 35 (10A). If the fuses are OK, go to Pinpoint Test E  under PINPOINT TESTS .
U0100 Lost Communication with ECM/PCM
  • Controller area network (CAN) bus fault
  • No data received by 4X4 control module from PCM
4X4 Control Module Go to Pinpoint Test D  under PINPOINT TESTS .
U0121 Lost Communication with Anti-lock Brake System (ABS) Control Module
  • CAN bus fault
  • No data received by 4X4 control module from ABS control module
4X4 Control Module Go to Pinpoint Test D  under PINPOINT TESTS .
U0415 Invalid Data Received From Anti-lock Brake System (ABS) Control Module
  • Invalid data received from ABS module
  • Data out of range
4X4 Control Module Go to Pinpoint Test C  under PINPOINT TESTS .