Front Controls Interface Module (FCIM): Installation
WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
- Align the FCIM to the instrument panel center finish panel so there is a consistent gap at the top of the FCIM .
- Install the 17 screws (vehicles without navigation) or 8 screws (vehicles with navigation).
- Adjust the FCIM , if necessary, by loosening the top screws, then re-tightening.
- Install the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
NOTE:
Lightly hand-tighten the screws. Do not use power tools.