FixVault
Home › Ford › 2009 › Edge SEL, AWD › Repair and Diagnosis › External Pages › Different car › Section 1488 (Information System & Entertainment System) › Removal And Installation › Front Display Interface Module (FDIM) › Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2009 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Module configuration is required when a new Front Display Interface Module (FDIM) is being installed.
  1. Upload the FDIM  configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION .
  2. Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    3. NOTE: For vehicles with navigation, make sure not to bend the FDIM  video feed cable when removing the FDIM  .
  3. Remove the 4 screws and the FDIM  .
    • Disconnect the electrical connector.
  4. To install, reverse the removal procedure.
    • Download the configuration information to the FDIM  . For additional information, refer to MODULE CONFIGURATION .
About FixVault