FixVault
Home › Ford › 2009 › Edge SEL, AWD › Repair and Diagnosis › External Pages › Different car › Section 1768 (Electronic Engine Control - Gasoline Engines) › Removal And Installation › Powertrain Control Module (PCM) › Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2009 Ford RV Cutaway, 2009 Ford Econoline, 2009 Ford E450 Super Duty, and 2009 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PCM and the 2 retaining nuts.

    • Tighten to 7 Nm (62 lb-in).
  2. Connect the 3 PCM electrical connectors.
    3. NOTE: If the PCM or Instrument Cluster (IC) is replaced (or both), the parameters must be reset in both modules or the vehicle will experience a Passive Anti-Theft System (PATS) no-start. This will occur even if the vehicle is not equipped with PATS  . For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
  3. Restore the module configurations for the IC  module and the PCM. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION article.
  4. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
About FixVault