FixVault
Home › Ford › 2010 › Explorer 4.6 8, AWD › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Handles, Locks, Latches And Entry Systems › General Procedures › Autolock and Auto-Unlock Programming › Auto-Unlock Programming Using the Ignition Lock Cylinder

Auto-Unlock Programming Using the Ignition Lock Cylinder

  1. Close all doors and windows.
  2. Confirm that the ignition key is OFF.
  3. NOTE: Steps 5 through 9 must be carried out within 30 seconds.

    Turn the ignition key from OFF to RUN.

  4. Press the door lock control switch UNLOCK button 3 times.
  5. Turn the ignition key from RUN to OFF.
  6. Press the door lock control switch UNLOCK button 3 times.
  7. Turn the ignition key from OFF to RUN.
  8. Verify the horn chirps. This indicates the enable/disable mode and now is ready to accept program changes.
  9. Press the door lock control switch LOCK button then the UNLOCK button 1 time to command the module to toggle the auto-unlock feature.
  10. Verify that the horn chirps. There should be 1 chirp indicating that auto-unlock feature has been disabled. If 1 chirp is heard, followed by a longer sound of the horn, the auto-unlock feature has just been enabled.
  11. Turn the key to the OFF position or wait 2 minutes to exit the enable/disable mode.
  12. Verify that the horn chirps once to indicate that a feature has been changed and that auto-unlock has been toggled.
About FixVault