Lumbar Assembly - Power: Installation

If equipped, position the TED duct between the power lumbar and cable.

Fig 1: Positioning TED
Courtesy of FORD MOTOR CO.
Engage the power lumbar retaining clips to the backrest frame and connect the motor.
If equipped, connect the backrest TED electrical connector and engage the pin-type retainer.
Roll the backrest cover down and attach the hook-and-loop strips.
Route the wire harness(es) through the hole(s) in the backrest cover and engage the lower J-clips.
On each side, wrap the backrest cover around the recliner and attach the hook-and-loop strips and clip.

Fig 2: Locating Backrest Cover
Courtesy of FORD MOTOR CO.
Install the seat backrest. For additional information, refer to SEAT BACKREST - FRONT .