FixVault
Home › Ford › 2011 › Edge SE, AWD › Repair and Diagnosis › External Pages › Different car › Section 2111 (Information System And Entertainment System) › Removal And Installation › Front Controls/Display Interface Module (FCDIM) › Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Module configuration is required when a new Front Control/Display Interface Module (FCDIM) is being installed.

    Upload the FCDIM  configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION to carry out Programmable Module Installation (PMI).

  2. Remove the Front Controls Interface Module (FCIM) refer to FRONT CONTROLS INTERFACE MODULE (FCIM) .
  3. Remove the 4 screws and remove the FCDIM  .
    • Disconnect the electrical connectors.
  4. To install, reverse the removal procedure.
    • Download the configuration information to the FCDIM  . For additional information, refer to MODULE CONFIGURATION to carry out PMI.
About FixVault