Removal and Installation

Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .

NOTE: Mark the steering wheel and column shaft for reference during installation.

Remove and discard the steering wheel bolt.
- To install, tighten the new bolt to 48 Nm (35 lb-ft).
Disconnect the steering wheel switches electrical connector.

NOTE: Do not remove the steering wheel by hitting the shaft with a hammer. Damage to the column may occur.

Using a suitable puller, remove the steering wheel.
Tape the clockspring center rotor to the outer housing to keep it from rotating.

Fig 1: Locating Clockspring Center Rotor
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Align the steering wheel using the reference mark.