Driver Air Bag Module: Installation
- Connect the driver air bag module and horn electrical connectors.
- Align the driver air bag module hooks to the steering wheel and seat the 3 driver air bag module hooks.
- When the 3 driver air bag module hooks are seated, gently pull outward at the corners of the driver air bag module to make sure all 3 hooks are fully seated. Check the driver air bag module and trim cover for correct movement when pressing the horn.
- Repower the SRS . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in the General Procedures portion of this service information.
NOTE:
Make sure the wiring harness is routed away from the driver air bag module hooks during installation.
NOTE:
Audible clicks will be heard when the 3 wire clips are seated in the 3 driver air bag module hooks.