Section 11 (Service Information -- Introduction)
WARNING: This page is about a different car, the 2012 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Symbols Glossary
- Notes
- Movement Symbols
- Turn Symbols
- Steering Wheel Symbols
- Body Types
- Gearshift lever and selector lever position symbols
- Screwdriver symbols
- Pliers Symbols
- Drill Symbols
- Cutting Tool Symbols
- Apply Chemical or load symbols
- Measurement Symbols
- General equipment symbols
- Welding Symbols
- Drilling and grinding symbols
- Material Symbols
- Miscellaneous Symbols
- Mandatory Protective Equipment - Health and safety symbols
- Prohibition - Health and safety symbols and component damage
- Warning Symbols - Health and Safety Warnings and Component damage
- Control Diagram symbols - Description and Operation procedures
- Using This Service Information
- Safety Warnings
- Notes
- General Service Health and Safety Precautions
- High Voltage System Health and Safety Precautions
- Climate Control System Health and Safety Precautions
- Battery and Battery Charging System Health and Safety Precautions
- Brake System Health and Safety Precautions
- Body Repair Health and Safety and General Precautions
- Engine Cooling System Health and Safety Precautions
- Gasoline and Gasoline-Ethanol Fuel System Health and Safety Precautions
- Diesel Fuel System Health and Safety Precautions
- Safety Belt and Supplemental Restraint System (SRS) Health and Safety Precautions
- Wheel and Tire Health and Safety Precautions
- Diagnostic Methods
- Effective Diagnostic Techniques
- Diagnostic Scan Tool Testing
- Integrated Diagnostic System (IDS) Scan Tool Usage
- If The IDS Scan Tool Does Not Communicate With The Vehicle
- Measuring Automotive Circuits
- Wiring Pin (Terminal) Fit And The Use Of Rotunda Flex Probes
- Checking Power-Providing Circuits
- Checking Ground-Providing Circuits
- Checking Circuit Continuity
- Checking For Unintended Continuity (Shorts) To Other Circuits
- Checking Circuits By Back-Probing A Connector
- Circuit Analysis Using Jumper Wires (Creating Substitute Circuits)
- Checking Modules
- Symbols Glossary