FixVault
Home › Ford › 2011 › Flex SE › Repair and Diagnosis › External Pages › Different car › Section 1906 (Information System And Entertainment System) › Removal And Installation › Audio Control Module (ACM) › Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is not necessary to remove the Audio Front Control Module (ACM) to retrieve the part number. For additional information, refer to AUDIO CONTROL MODULE (ACM) SELF-DIAGNOSTIC MODE  .

All vehicles 

    NOTE: Module configuration is required when a new ACM is being installed.
  1. Upload the ACM configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION .

    Vehicles without navigation 

  2. Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .

    Vehicles with navigation 

  3. Remove the Front Display Interface Module (FDIM). For additional information, refer to FRONT DISPLAY INTERFACE MODULE (FDIM)  .

    All vehicles 

  4. Remove the 4 screws and the ACM.
    • Disconnect the electrical connectors and the antenna lead-in cable.
  5. To install, reverse the removal procedure.
    • Download the configuration information to the ACM. For additional information, refer to MODULE CONFIGURATION .
About FixVault