FixVault
Home › Ford › 2011 › Flex SE › Repair and Diagnosis › External Pages › Different car › Section 1906 (Information System And Entertainment System) › Removal And Installation › Front Controls Interface Module (FCIM) › Installation

Front Controls Interface Module (FCIM): Installation

WARNING: This page is about a different car, the 2012 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the FCIM to the instrument panel center finish panel so there is a consistent gap at the top of the FCIM.
    Fig 1: Location of Top Of FCIM
    G08043950Courtesy of FORD MOTOR CO.
    2. NOTE: Lightly hand-tighten the screws. Do not use power tools.
  2. Install the 17 screws (vehicles without navigation) or 8 screws (vehicles with navigation).
    • Adjust the FCIM, if necessary, by loosening the top screws, then re-tightening.
  3. Install the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
About FixVault