Removal and Installation

Remove the RH front seat. For additional information, refer to Seat - Front in SEAT SYSTEM - SEATS article.
Remove the pin-type retainer and position the RH rear footwell duct aside.

Fig 1: Locating Rear Footwell Duct
Courtesy of FORD MOTOR CO.
Remove the 3 stability control sensor cluster bolts and position the sensor cluster to access the electrical connector.
- To install, tighten to 10 Nm (89 lb-in).
Disconnect the electrical connector and remove the sensor cluster assembly.
Remove the 2 stability control sensor cluster nuts and the stability control sensor cluster.
- To install, tighten to 8 Nm (71 lb-in).
To install, reverse the removal procedure.
- Carry out the IVD Initialization sequence. Follow the scan tool directions.