FixVault
Home › Ford › 2011 › Mustang Base, 2D Convertible, Standard › Repair and Diagnosis › External Pages › Different car › Section 1344 (Supplemental Restraint System) › Removal And Installation › Restraints Control Module (RCM) › Installation

Restraints Control Module (RCM): Installation

WARNING: This page is about a different car, the 2010 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
  1. Position the RCM  and install the nuts.
    • Tighten to 12 Nm (106 lb-in).
  2. Connect the small RCM  electrical connector.
  3. Verify that the CPA  lever is positioned back completely (as shown in illustration) before connecting the large RCM  connector.
    Fig 1: Locating CPA Lever
    G06063829Courtesy of FORD MOTOR CO.
    4. NOTE: Placing the large Restraints Control Module (RCM) electrical wiring connector into the RCM  on an angle can cause bad electrical connections and damaged components.
  4. Position the large RCM  electrical connector into the RCM  .
      NOTE: Do not push the connector such that the Connector Position Assurance (CPA) lever pivots and seats. Use light force to insert the connector into the Restraints Control Module (RCM) before using the CPA  lever to lock the connector. Damage to the connector or component may occur.
      Fig 2: Locating RCM Electrical Connector
      G06063830Courtesy of FORD MOTOR CO.
    • With the large RCM  electrical connector uniformly aligned to the RCM  , push in until a slight resistance is felt.
  5. Connect the large RCM  connector.
    • Insert the connector into the RCM  .
      • Push to lock the CPA  lever thumb tab to the RCM  .
        Fig 3: Locating Large Electrical Connector
        G06063831Courtesy of FORD MOTOR CO.
  6. Install the floor console. For additional information, refer to the Removal and Installation procedures in INSTRUMENT PANEL AND CONSOLE .
  7. Repower the SRS  . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING  in the General Procedures portion of this section.
  8. If a new RCM  was installed, carry out the appropriate steps necessary to complete PMI  . For additional information, refer to MODULE CONFIGURATION .
About FixVault