Removal and Installation

NOTE: Do not allow the clockspring to rotate while the steering wheel is disconnected or damage to the clockspring may result. If there is evidence that the clockspring has rotated, the clockspring must be recentered. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM Article.

Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM Article.
Remove and discard the steering wheel bolt.
- To install, tighten to 47 Nm (35 lb-ft).
Remove the steering wheel.
- Disconnect the steering wheel switches electrical connector from the clockspring.
- Route the 2 driver air bag module electrical connectors and harness through the steering wheel.
  
  Fig 1: Locating Driver Air Bag Module Electrical Connectors
  Courtesy of FORD MOTOR CO.
Tape the clockspring center rotor to the outer housing to keep it from rotating.

Fig 2: Locating Taped Clockspring Center Rotor
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- If installing a new steering wheel, transfer parts as needed:
  - For steering wheel controls, refer to INFORMATION SYSTEM AND ENTERTAINMENT SYSTEM Article.
  - For paddle shifters, refer to AUTOMATIC TRANSMISSION - AUTOMATIC TRANSAXLE/TRANSMISSION - EXTERNAL CONTROLS Article.
Install the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM Article.