FixVault
Home › Ford › 2012 › Explorer Base, 2.0 9 › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Handles, Locks, Latches And Entry Systems - With Intelligent Access › General Procedures › Autolock Programming › Programming the Autolock Feature Using the Keyless Entry Keypad

Programming the Autolock Feature Using the Keyless Entry Keypad

  1. Place the ignition to the OFF mode and close all vehicle doors.
  2. Enter the factory set 5-digit keyless entry keypad code.
  3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press the 7/8 button.
  4. Release the 7/8 button, then release the 3/4 button. The horn chirps once if autolock is disabled or twice (one short chirp followed by a honk) if autolock is enabled.
About FixVault