Pinpoint Test

1. Ignition ON.
2. Verify there is an observable symptom present.

Is an observable symptom present? 

1. Yes: GO to 2  .
2. No: The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

1. Ignition ON.
2. Using a scan tool, perform a network test.

Does the C-CM pass the network test? 

1. Yes: GO to 3  .
2. No: REFER to DIAGNOSTIC ROUTINE U : The Cruise-Control Module (C-CM) Does Not Respond To The Scan Tool.

1. Using a scan tool, perform the C-CM  self-test.

Is DTC U3003:16 or DTC U3003:17 recorded? 

1. Yes: REFER to Diagnostic Routine Q: U3003:16 , or REFER to Diagnostic Routine R: U3003:17 .
2. No: GO to 4  .

1. Using a scan tool, clear all DTCs  .
2. Ignition OFF.
3. Wait 10 seconds.
4. Ignition ON.
5. Repeat the PCM self-test.

Is DTC U0104 still present? 

1. Yes: GO to 5  .
2. No: The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

1. Clear all DTCs  .
2. Ignition OFF.
3. Wait 10 seconds.
4. Ignition ON.
5. Using a scan tool, retrieve the continuous memory DTCs  from all modules.

Is DTC U0104 or U0104:00 set in other modules? 

1. Yes: INSTALL a new C-CM  . REFER to Cruise Control Module (C-CM) .
2. No: INSTALL a new PCM. REFER to POWERTRAIN CONTROL MODULE (PCM) - 2.0L GTDI , or POWERTRAIN CONTROL MODULE (PCM) - 3.5L TI-VCT .