Section 120 (Driveline System - General Information): Specifications

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

MATERIAL SPECIFICATIONS

Item

Specification

Fill Capacity

Additive Friction Modifier
XL-3 (US); CXL-3 (Canada)

EST-M2C118-A

4 oz (Traction-Lok® only). 6 oz (If equipped with rear differential oil cooler).

Motorcraft® SAE 75W-140 Synthetic Rear Axle Lubricant
XY-75W140-QL (US); CXY-75W140-1L (Canada)

WSL-M2C192-A and GL-5

8.8-in rear axle. ⁽¹⁾⁽²⁾

Motorcraft® SAE 75W-85 Premium Synthetic Hypoid Gear Lubricant
XY-75W85-QL

WSS-M2C942-A

SVT 8.8-in rear axle. ⁽¹⁾⁽²⁾

Premium Long-Life Grease
XG-1-C or XG-1-K (US); CXG-1-C (Canada)

ESA-M1C75-B

Threadlock 262
TA-26

WSK-M2G351-A6

⁽¹⁾	Service refill capacities are determined by filling the axle to a level of 5mm below the bottom of the filler hole. The vehicle must be on a level surface.

⁽²⁾	Vehicles equipped with a rear differential oil cooler. Refer to the appropriate procedure.

GENERAL SPECIFICATIONS

Item	Specification
Maximum driveshaft runout	0.89 mm (0.035 in)
Maximum pinion flange runout	0.25 mm (0.009 in)
Maximum transmission flange runout	0.20 mm (0.008 in)
Minimum rotational torque (Traction-Lok®)	27 Nm (20 lb-ft)