General Procedure

Using alignment equipment and the manufacturer's instructions, measure the front toe.
Start the engine and center the steering wheel.
Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
Remove the steering gear bellows clamps.

Fig 1: Locating Steering Gear Bellows Clamps
Courtesy of FORD MOTOR CO.
Loosen the tie-rod end jam nuts (1 each side).

Fig 2: Locating Tie-Rod End Jam Nut
Courtesy of FORD MOTOR CO.

NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.

Rotate the tie rods as necessary to adjust the toe setting.
Tighten the tie-rod end jam nuts.
- Tighten to 63 Nm (46 lb-ft).
Fig 3: Locating Tie-Rod End Jam Nut
Courtesy of FORD MOTOR CO.
Recheck the toe settings and adjust as necessary.
Install the steering gear bellows clamps.