Removal and Installation
- Remove the LH front seat. For additional information, refer to SEATING .
- Remove the scuff plate trim panel and the cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the FP control module electrical connector.
- Remove the 2 FP
control module nuts.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
NOTE:
The Fuel Pump (FP) control module is located on the rear surface of the LH front seat mount.
NOTE:
Do not overtighten the fasteners or damage to the module may occur.