FixVault
Home › Ford › 2012 › Focus S, Automatic DCT Trans, Gas › Repair and Diagnosis (Single Page) › Engine Performance › Remove, Overhaul & Install › Electronic Engine Controls - 2.0L DURATEC-He › Removal and Installation › Powertrain Control Module (PCM) › Installation

Powertrain Control Module (PCM): Installation

  1. To install, reverse the removal procedure.
    2. NOTE: This step is only necessary when installing a new component.
  2. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure.

    Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION .

    General Equipment  : Ford Diagnostic Equipment

  3. Reprogram the PATS

    Refer to: Passive Anti-Theft System (PATS) Parameter Reset  ( PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET ).

    Refer to: Passive Anti-Theft System (PATS) Parameter Reset  ( PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET (Push Button Start) ).

About FixVault