Removal and Installation

NOTE: The radial arm adapter is a serviceable item. Do not replace the generator if the radial arm adapter is the only concern.

Remove the A/C compressor. For additional information, refer to CLIMATE CONTROL .
Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (106 lb-in).
Disconnect the generator electrical connector.
- Detach the pin-type retainer and wiring harness.
Remove the oil filter.
- Lubricate the oil filter seal with clean engine oil before installation.
Position the engine wiring harness aside.
Remove the generator stud nut.
- To install, tighten to 47 Nm (35 lb-ft).
Remove the generator bolt and the generator.
To install, reverse the removal procedure.