FixVault
Home › Ford › 2012 › Mustang Base, 2D Convertible, Automatic Trans › Repair and Diagnosis › Body & Frame › Seat System - Seats › Disassembly And Assembly › Seat Backrest - Front › Assembly

Seat Backrest - Front: Assembly

  1. Attach the 4 hooks and install the lumbar assembly to the backrest frame.
    • If equipped, connect the power lumbar electrical connector.
  2. Install the backrest latch release and 2 rivets.
    • If necessary, install a tie strap, holding the cable to the backrest frame.
  3. Route the backrest latch release cable as noted during disassembly and install the cable and casing to the outboard recliner.
    4. NOTE: When installing a new side air bag module after deployment, install a new side air bag module, bracket, module-to-bracket nuts, U-nuts-to-backrest frame and side air bag module bracket-to-seat backrest frame bolts.
  4. For seats receiving a new side air bag module, install 2 new U-nuts to the backrest frame, install a new bracket to the side air bag module and 2 nuts.
    • Tighten the nuts to 6 Nm (53 lb-in).
    5. WARNING: Inspect the seat side air bag module and mounting surfaces for any damage or foreign material before installing the seat side air bag module. If any damage is found, install new components. If any foreign material is found, remove it. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a crash.
    WARNING: If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
    NOTE: To avoid component damage, make sure the side air bag module wiring harness is not pinched between the side air bag module and the mounting bracket.
  5. Install the side air bag module and 2 bolts to the backrest frame.
    • Tighten to 10 Nm (89 lb-in).
    • Attach the wiring pin-type retainers to the seat backrest frame.
  6. Install the backrest foam pad.
  7. Install the seat backrest cover. For additional information, refer to SEAT BACKREST COVER - FRONT .
About FixVault