Toe Adjustment - Front
- Start the engine and center the steering wheel.
- Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.
- Using alignment equipment and the manufacturer's instructions, measure the front toe.
- Remove the clamps.
- Loosen the tie-rod jam nuts.
- Rotate the inner tie rods until the toe reading is within specifications.
- Tighten the tie-rod jam nuts to 55 Nm (41 lb-ft).
- Install the clamps.
- Recheck the toe settings and adjust as necessary.
NOTE:
Do not allow the steering gear bellows to twist when the inner tie rod is rotated.
NOTE:
Do not allow the inner tie rods to rotate while tightening the tie-rod jam nuts.