FixVault
Home › Ford › 2012 › Taurus SE › Repair and Diagnosis › External Pages › Different car › Section 2336 (Information System And Entertainment System - 8 Inch Touchscreen) › General Procedures › Touchscreen Calibration

Touchscreen Calibration

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Calibrate the touchscreen by following the diagnostic scan tool prompts, or the steps below.
  1. Make sure the vehicle battery is fully charged in order to avoid an inoperative touchscreen.
  2. Turn the ACM on.
  3. Operate the audio system in radio tuner AM/FM mode.
  4. Press and hold the eject button, and within 1 second, press and hold the seek up button until the speaker walk around test begins.
  5. Press and hold the seek down button to enter the touchscreen calibration.
  6. Touch and hold the touch points as they appear on the touchscreen (a stylus is not required).
  7. When "New calibration settings have been measured. Press the Enter key to accept the new settings." is displayed, touch anywhere on the screen to accept the new settings.
  8. Clear all CMDTCs.
About FixVault