Front Planetary and One-Way Clutch Assembly: Assembly

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Front One-Way Clutch Into Special Tool (307-391) With Brass End Cap Facing Up

GF0010258

Courtesy of FORD MOTOR CO.

NOTE: This step only needs to be carried out if the bearing was removed.

Install the front one-way clutch into the special tool with the brass end cap facing up.

Fig 2: Inspecting Front One-Way Clutch Is Flush With Special Tool (307-391)

GF0010259

Courtesy of FORD MOTOR CO.

NOTE: This step only needs to be carried out if the bearing was removed.

Inspect that the front one-way clutch is flush with the special tool.

Fig 3: Identifying Special Tools (307-391, 307-392)

GF0010260

Courtesy of FORD MOTOR CO.

NOTE: This step only needs to be carried out if the bearing was removed.

Assemble the special tools with the front one-way clutch onto the center shaft.

Fig 4: Pushing Down On Center Shaft To Seat Front One-Way Clutch Into Center Shaft Using Special Tools (307-391, 307-392)

GF0010261

Courtesy of FORD MOTOR CO.

NOTE: This step only needs to be carried out if the bearing was removed.

Push down on the center shaft to seat the front one-way clutch into the center shaft.

Fig 5: Inspecting Front One-Way Clutch For Correct Installation & Function

GF0010262

Courtesy of FORD MOTOR CO.

NOTE: This step only needs to be carried out if the bearing was removed.

Inspect the front one-way clutch for correct installation and function. The front one-way clutch tabs should be flush with the center shaft.

Fig 6: Installing Center Shaft & One-Way Clutch Onto Overdrive Ring Gear

GF0010263

Courtesy of FORD MOTOR CO.

Install the center shaft and one-way clutch onto the overdrive ring gear.
1. Install the center shaft and one-way clutch.
2. Install the center shaft retaining ring.