Intermediate Shaft Speed Sensor: Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect and lubricate the O-ring with petroleum jelly.
Install the intermediate shaft speed sensor into the transmission.
- Install the intermediate shaft speed sensor screw.
- Tighten to 10 Nm (89 lb-in).
- Connect the intermediate shaft speed sensor electrical connector.
- Lower the vehicle.
NOTE:
Inspect the intermediate shaft speed sensor O-ring for damage. If damaged, install a new O-ring.