2.3L engine

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Transmission To Engine Bolts

Courtesy of FORD MOTOR CO.

NOTE: Align the flexplate to the converter marks made at removal.

Install the screws.
1. Install 1 M10 x 40 mm (1.57 in) screw.
2. Install 4 M10 x 50 mm (1.96 in) screws.
3. Install 2 M10 x 75 mm (2.95 in) screws.
- Tighten to 55 Nm (41 lb-ft).

Fig 2: Identifying Upper Fluid Filler Tube And Bracket Bolt

Courtesy of FORD MOTOR CO.

Install the upper fluid filler tube and bracket screw.
1. Install the upper filler tube.
Install the M10 x 50 mm (1.96 in) screw.
- Tighten to 55 Nm (41 lb-ft).

Fig 3: Locating Transmission-To-Engine Lower Screws

Courtesy of FORD MOTOR CO.

Install the lower transmission-to-engine screws.
- Tighten to 55 Nm (41 lb-ft).

Fig 4: Locating HO2S Connector Bracket Bolt

Courtesy of FORD MOTOR CO.

Install the HO2S connector bracket.
- Tighten to 20 Nm (15 lb-ft).

Fig 5: Locating Rear Engine Cover Plate

Courtesy of FORD MOTOR CO.

Install the rear engine cover plate.
- Tighten to 10 Nm (89 lb-in).