Fluorescent Dye Detection

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Ford Motor Company vehicles are produced with R-134a fluorescent dye installed in the refrigerant system from the factory. The location of leaks can be pinpointed by the bright yellow-green glow of the fluorescent dye under a Rotunda-approved UV lamp. Since more than one leak can exist, make sure to inspect each component, line and fitting in the refrigerant system for a leak.

NOTE: Use of dye-enhancing glasses or goggles greatly improves the detection of the dye under the Rotunda-approved UV lamp.

NOTE: Not all UV lamps will fluoresce the dye used in Ford vehicles. All Rotunda UV lamps are optimized to fluoresce the dye.

1.

Check for leaks using a Rotunda-approved UV lamp and dye enhancing glasses.

2.

Inspect all components, lines and fittings of the refrigerant system.

3.

After the leak(s) is repaired, remove any traces of fluorescent dye with a general purpose oil solvent.

4.

Verify the repair by running the vehicle for a short period of time and rechecking the area of the leak with a Rotunda-approved UV lamp.
- UVU413025 UV Leak Detection Light U?ViewUse the General Equipment: UV Leak Detector