DTC Chart: FCDIM

WARNING: This page is about a different car, the 2014 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

DTC	Description	Action
B11BA:1C	Steering Wheel Audio Switch Pack: Circuit Voltage Out of Range	GO to PINPOINT TEST T
B11BA:63	Steering Wheel Audio Switch Pack: Circuit/Component Protection Time-Out	GO to PINPOINT TEST T
U0155:00	Lost Communication With Instrument Panel Cluster IPC Control Module: No Sub Type Information	GO to PINPOINT TEST AA
U0184:00	Lost Communication With Radio: No Sub Type Information	GO to PINPOINT TEST AB
U0253:00	Lost Communication With Accessory Protocol Interface Module	GO to PINPOINT TEST AC
U2013:87	Switch Pack: Missing Message	GO to PINPOINT TEST V
U201A:51	Control Module Main Calibration Data: Not Programmed	This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM . If there have been recent service actions with the FCDIM , REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PROGRAMMABLE MODULE INSTALLATION (PMI) . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. Refer to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM . If there have been recent service actions with the FCDIM , REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PROGRAMMABLE MODULE INSTALLATION (PMI) . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. Refer to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	This DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to the FCDIM . If there have been recent service actions with the FCDIM , REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PROGRAMMABLE MODULE INSTALLATION (PMI) . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. Refer to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U3000:41	Control Module: General Checksum Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCDIM . Refer to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCDIM . Refer to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) .
U3003:16	Control Module Input Power "A": Circuit Voltage Below Threshold	GO to PINPOINT TEST AE
U3003:17	Control Module Input Power "A": Circuit Voltage Above Threshold	GO to PINPOINT TEST AF