FixVault
Home › Ford › 2013 › Escape Titanium, AWD › Repair and Diagnosis › External Pages › Different car › Section 70 (Auxiliary Brake System) › Removal And Installation › Trailer Brake Control (TBC) Module › Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel upper center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. NOTE: The clips holding the coin tray/storage bin or the auxiliary switch assembly (if equipped) to the center finish panel are very stiff. Care must be taken not to damage the coin tray/storage bin, switch assembly or center finish panel during removal.

    Press the 4 tabs and remove the coin tray/storage bin or the switch assembly (if equipped).

    Fig 1: Locating Coin Tray/Storage Bin Tabs
    G06762823Courtesy of FORD MOTOR CO.
  3. Remove the Trailer Brake Control (TBC) module.
  4. To install, reverse the removal procedure.
About FixVault