Section 226 (Module Communications Network -- (Except Electric))
WARNING: This page is about a different car, the 2014 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Communications Network - Overview
- Communications Network - System Operation and Component Description
- System Operation
- Medium Speed Controller Area Network (MS-CAN)
- Notes
- Infotainment Controller Area Network (I-CAN)
- Controller Area Network (CAN) Fault Tolerance
- Fault Tolerance Normal Operation
- CAN Circuits Shorted Together
- CAN (+) Circuit Shorted to Ground
- CAN (-) Circuit Shorted to Ground
- CAN (+) Circuit Shorted to Battery Voltage
- CAN (-) Circuit Shorted to Battery Voltage
- CAN Circuit Signal Corruption
- CAN Multiplex Messages
- Diagnosis And Testing
- Communications Network
- DTC Chart
- Symptom Chart(s)
- Diagnostic Routines
- PINPOINT TEST A: The Powertrain Control Module (PCM) Does Not Respond To The Scan Tool
- PINPOINT TEST B: The Anti-Lock Brake System (ABS) Module Does Not Respond To The Scan Tool
- PINPOINT TEST C: The RCM Does Not Respond To The Scan Tool
- PINPOINT TEST D: The FCDIM Does Not Respond To The Scan Tool
- PINPOINT TEST E: The OCSM Does Not Respond To The Scan Tool
- PINPOINT TEST F: The SASM Does Not Respond To The Scan Tool
- PINPOINT TEST G: The IPC Does Not Respond To The Scan Tool
- PINPOINT TEST H: The ICM Does Not Respond To The Scan Tool
- PINPOINT TEST I: The BCM Does Not Respond To The Scan Tool
- PINPOINT TEST J: The HVAC Module Does Not Respond To The Scan Tool
- PINPOINT TEST K: The ACM Does Not Respond To The Scan Tool
- PINPOINT TEST L: The DSP Does Not Respond To the Scan Tool
- PINPOINT TEST M: The DDM Does Not Respond To the Scan Tool
- PINPOINT TEST N: The PDM Does Not Respond To The Scan Tool
- PINPOINT TEST O: The IPMB Does Not Respond To The Scan Tool
- PINPOINT TEST P: The GPSM Does Not Respond To The Scan Tool
- PINPOINT TEST Q: The PAM Does Not Respond To The Scan Tool
- PINPOINT TEST R: The APIM Does Not Respond To The Scan Tool
- PINPOINT TEST S: The FCIM Does Not Respond To The Scan Tool
- PINPOINT TEST T: The RFA Module Does Not Respond To The Scan Tool
- PINPOINT TEST U: The TCM Does Not Respond To The Scan Tool
- PINPOINT TEST V: The PSCM Does Not Respond To The Scan Tool
- PINPOINT TEST W: No HS-CAN Communication, All Modules Are Not Responding
- PINPOINT TEST X: No MS-CAN Communication, All Modules Are Not Responding
- PINPOINT TEST Y: No Infotainment Controller Area Network (I-CAN) Communication, All Modules Are Not Responding
- PINPOINT TEST Z: No Power To The DLC
- Communications Network
- General Procedures